Publicidad
Idiomas disponibles
Idiomas disponibles
6.
Push the rocker switch 3 forwards and hold it.
The saw drive starts, and the machine
➢
stays in its position.
7.
Use the plunge bar 4 to press the saw unit into
the workpiece until it engages with the clamping
lever 6.
8.
Keeping the rocker switch 3 pressed, slowly
increase the feed speed using the rotary switch
1.
The saw unit now cuts through the
➢
material until it reaches the stop slide 7.
The latch is now released, and the saw
blade swings back into the fixed blade
guard.
Release the rocker switch 3 when the
➢
plunge cut is finished. The saw drive
stops.
9.
Use rocker switch 3 to return the saw unit and
its saw blade to the home position.
The plunge cut is complete.
✓
5.10 Scoring
The integrated scoring device of the panel saw system allows splinter-free cuts of overlaid boards. The saw
blade is offset by only ca. 0.15 mm [0.01 in] to the cutting path.
Use the following procedure to use the scoring
function of the machine:
1.
Turn the scoring lever 8 to the "scoring"
position.
2.
Set the cutting depth to 2 mm.
3.
Make the scoring cut.
4.
Then move the saw unit back to its starting
position.
26
Fig. 19: Plunge cutting
Fig. 20: Activating the scoring function
PSS 3100 SE
01/2022
Publicidad
