Publicidad
Idiomas disponibles
Idiomas disponibles
PSS 3100 SE
6.3 Transport
Damaging the machine by bending the guide rails
Transporting or storing the machine with the guide rail extension attached may bend and deform the guide
rails.
Always remove the guide rail extension when transporting or storing the machine.
➢
A bow-type handle is attached to the machine for carrying it across longer distances. The bow-type handle's
position on the guide rail must be adjusted to the system's center of gravity.
Use the following procedure to adjust the bow-
type handle:
1.
Remove the extension if attached.
2.
Remove the Allen key B from its holder in the
machine and loosen the two Allen screws 26.
3.
Move the bow-type handle 27 in the groove of
the guide rail until the marking 28 is in the
center of the bow-type handle.
4.
Re-tighten the Allen screws 26 and put the Allen
key B back into its holder on the motor housing.
The bow-type handle is adjusted to an
✓
ergonomic transport position.
01/2022
Notice
Fig. 26: Adjusting the bow-type handle to an ergonomic
transport position
31
Publicidad
