Chip Extraction; Changing The Saw Blade - Mafell P1cc Manual De Instrucciones

4.3 Chip extraction

For all work that produces a significant amount of dust, connect the machine to a suitable external extraction
device. The air velocity must be at least 20 m/s [65 ft/sec].
The outside diameter of the hose connector is 29 mm [1.14 in].

4.4 Changing the saw blade

Use the following procedure to change the saw
blade:
1. Pull out the power plug of the machine.
2. Put down the cable where you can see it.
3. Put the disconnected machine on a flat surface.
4. Swivel the clamping lever (2) outward until it
locks into place.
5. Remove the saw blade.
➢ The saw blade is ejected automatically
when you press lightly on its side.
12
Caution
Health hazards from wood dust
The dusts produced during work can be inhaled and can cause health damage.
Harmful dust must be extracted with a HEPA 13 dust extractor.
➢
➢ Wear a dust mask during work.
Caution
Risk of injury from the sharp saw blade
The saw blade is sharp. You can hurt yourself when you change the saw blade.
Wear protective gloves when you change the saw blade.
➢
➢ Be careful when you change the saw blade.
Fig. 3: Removing the saw blade
P1cc
11/2021