Operation; Startup; Switching On / Off - Mafell P1cc Manual De Instrucciones

5

Operation

5.1 Startup

These operating instructions must be brought to the attention of all persons entrusted with the operation of the
machine, with particular emphasis on the chapter "Safety instructions".

5.2 Switching on / off

There are markings on the slide switch that indicate the switching state.
Use the following procedure to switch on the
machine:
1. Push the slide switch (1) in the direction of the
base plate.
➢ Marking I is visible.
The machine is switched on.
✓
Use the following procedure to switch off the
machine:
1. Push the slide switch (1) away from the base
plate.
➢ Marking 0 is visible.
The machine is switched off.
✓
When the machine is switched on, the integrated electronics ensure jerk-free acceleration
and, under load, readjust the speed to the fixed set value.
In addition, these electronics regulate the motor back in case of overload, i.e. the saw blade
is stopped.
Switch on the machine only when the saw blade is inserted.
At the setting wheel (4), you can adjust the rotational
speed continuously between 800 and 3000 rpm.
16
Fig. 10: Switching the machine ON/OFF
Fig. 11: Selecting the rotational speed at the setting wheel
P1cc
11/2021