Using The Precision Jigsaw On The Guide Rail - Mafell P1cc Manual De Instrucciones

P1cc

4.7 Using the precision jigsaw on the guide rail

The machine can be used on the guide rail. One half of the base plate protrudes beyond the rail in this case.
The rail thickness is compensated for by mounting a glider.
Use the following procedure to install the glider:
1. Insert the hook of the glider (7) into the
recesses provided on the base plate. Glider and
base plate form an angle of approximately 30°.
2. Press the glider (7) against the base plate until
the pin engages in the borehole.
3. Position the machine on the rail such that the
groove of the base plate engages over the
spring of the rail.
✓ Glider installed.
Use the following procedure to remove the glider:
1. Reach with your finger into the recess provided
and lift the glider. Swivel the glider to a position
approx. 30° away from the base plate.
2. Remove the hook from the recesses of the base
plate and remove the glider.
Glider removed.
✓
11/2021
Fig. 8: Installing the glider
Fig. 9: Removing the glider
15