Mafell KSS300 Instrucciones De Funcionamiento Y Seguridad página 16

Use the following procedure to change the saw
blade:
1. Pull out the power plug of the machine.
2. Put down the cable where you can see it.
3. Put the disconnected machine on a flat surface.
4. To move the movable guard to the maximum
open position, either use the pre-feed lever (3)
or do it manually.
➢ To remove the saw blade, manually hold
the guard in the open position.
5. Press and hold the locking pin (10).
6. Insert the Allen key (B) into the flange screw
(11) and turn it counterclockwise until the saw
shaft locks home into the locking device.
The saw blade is retained in position and
➢
the flange screw can be released.
7. Using the Allen key (B), turn the flange screw
(11) counterclockwise to loosen it.
You can now release the locking pin.
➢
8. Remove the flange screw (11) and the front
clamping flange (12).
9. Remove the old saw blade.
Clamping flanges must be free of adhering
➢
parts!
➢ The new saw blade can now be installed.
16
Fig. 6: Locking the saw shaft
Fig. 7: Removing the old saw blade
KSS300
01/2022