Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS - RECIRCULATING (NON-VENTED)
Use these instructions if the appliance will not be vented to the outside.
Install the mounting plate
Use a 5/8" drill to make two holes that will enter the drywall. Use a 3/16" drill to make a hole that will
enter a wall stud. Use the mounting template to decide the location of the holes. At least one hole must
enter a wall stud.
Insert the machine screws into the mounting plate through the holes designed to go into drywall and attach
the wing nuts 3/4" onto each machine screw.
Place the mounting plate against the wall and insert the wing nuts into the holes in the wall. The wing nuts
will open on the other side of the wall to secure the screw.
Do not place a wing nut on the screw that will go into the wall stud. Insert a wood screw through the
mounting plate and into the wall stud. Tighten all screws.
Using the top cabinet template
There are instructions on the top cabinet template
that detail how it should be used.
Tape the top cabinet template to the under side of
the cabinet where the microwave will be installed.
Drill holes for the top support screws, a hole large
enough for the power cord to fi t through and a
cutout large enough for the exhaust adapter.
Spacing for Toggles More
Than Wall Thickness
Wing nut
machine
screw
Plate
Wall
19
Bolt End
Publicidad
