Skil CR5440B-00 Manual Del Propietário página 20

Cutting Large Sheets
Large sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the blade will tend to bind, causing
KICKBACK and extra load on the motor
(Fig. 13a).
Support the panel or board close to the cut, as
shown in (Fig. 13b). Be sure to set the depth of
the cut so that you only cut through the sheet
or board, not the table or work bench. The two-
by-fours used to raise and support the work
should be positioned so that the broadest sides
support the work and rest on the table or bench.
Do not support the work with the narrow sides
as this is an unsteady arrangement. If the sheet
or board to be cut is too large for a table or
work bench, use the supporting two-by-fours on
the floor and secure.
20
Fig. 13a
Fig. 13b
Incorrect
Correct