Infiniton FGC-210B Manual De Instrucciones página 43

c) Remove the adjustable front stands below the
lower hinge. Then, loosen the 4 screws that hold
the lower hinge and remove it from the fridge.
The removal of the doors is now finished.
a) lnstall the removed parts on the opposite side of
the appliance. Pull the door socket, as shown in
the following figure, and install it in the respec­
tive position on the other side.
-
....
o
b) Remove the screws from the stopper, as shown
in the following figure, and install it on the oppo­
site side of the door.
c) Remove the shatt and the two stoppers from
the lower hinge and install it in the position, as
shown in the following figure.
lnstall the refrigerator
site side.
a) Remove the adjustable stand in the front, as
shown below. Then, install the lower hinge
on the other side of the fridge and tighten the
screws.
b) lnstall the shorter adjustable stand in the front
on the side, where the lower hinge is. By tuming
the stand, you can adjust the height on this side
of the appliance unti I il is levelled out.
Step 3
a) Attach the freezer door, turn the middle hinge
º
180
the appliance. Attach the middle hinge with the
3 corresponding screws.
e)
7
•
bl Attach the refrigerato : r door and install the upper
hinge on the opposite side of the appliance.
Attach the upper hinge with the 4 corresponding
screws. Also, attach the loop of the ground cable
with one of the four screws. Afterwards, connect
the cable link. Attach the upper hinge cover with
a screw.
el lnstall the gap cover on the opposite side of the
appliance and tighten the screw.
/
.
.
Finally, check for the right alignment of the
doors and that they clos.e properly on all sides. lf
necessary, adjust the stands in the front for a tully
horizontal positioning ot the appliance.
11 you have tilted the appliance by more !han
°
30 , please wait 4 hours befare you connect the
appliance to the mains supply.
an. d freezer doors on the oppo­
ll
am
and then install it on the opposite side ot
.
Step 4
Step 5