Operating instructions SATA multi clean 2
EN
5 seconds.
■ Then press the rinsing button [1-2] for approx. 5 seconds.
■ If rinsing inadequate, repeat rinsing after approx. 30 seconds and press
blowing button for approx. 5 seconds.
11.4. End rinsing
■ Open cover [1-14].
■ Take the spray gun with cup [2-7] off the long nozzle [2-6] / [3-2].
■ Unscrew the air cap of the spray gun and check for any residues inside,
blow clear with air if necessary.
■ Remove the cup lid [2-2].
■ Place cup lid on cup.
■ Close lid when not in use.
■ Possibly switch external extraction off.
12. Maintenance and repairs
Notice!
For repairs and maintenance work, depressurise the cleaning equipment
and vent it completely.
Notice!
Too many impurities in the cleaning agent and sediment in the bottom
of the cleaning agent tank shortens the service life of the double mem-
brane pump and makes the factory guarantee null and void.
12.1. Filling and emptying the collecting tanks
Notice!
Every time that the cleaning agent tanks have been filled and emptied,
replace the filter mat [3-6], (# 38042) (see chapter 12.2). A new filter mat
extends the service life of the cleaning agent.
■ Close the ball valve [3-6].
■ Take the collecting tank [1-6] with the cleaning agent tanks out of the
cleaning equipment.
■ Disconnect and remove the rinsing agent tank [1-7] .
■ Empty the rinsing agent tank.
■ Remove the cleaning agent tank [1-8].
■ Empty the cleaning agent tank.
86