Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
SYMPTOM
Trigger inoperative
Drive screw does not
return and/or keeps
spinning off
Tool does not spin off
Item numbers in bold refer to general assembly drawings and parts list (pages 18-19).
Other symptoms or failures should be reported to your local Stanley Engineered Fastening authorised distributor or repair
centre.
22
POSSIBLE CAUSE
Static friction
Low air pressure
Valve piston remains stuck
Lip seal 18 is defective
Adaptornut 92 loose
No air supply
Rear casing unscrewed by more than
5 turns
'O'ring 82 leaking air
Distributor stuck
Air motor jammed
O R I G I N A L I N S T R U C T I O N
REMEDY
Depress trigger a few times
Increase air pressure
Depress trigger several times. Lubricate
tool through air inlet. If unsuccessful,
dismantle, clean and lubricate trigger
elements
Replace
Tighten
Connect
Set tool stroke 5 turns
Replace
Lubricate
Lubricate tool at air inlet. If insufficient
dismantle and clean air motor thoroughly
PAGE REF.
17
18
Publicidad
