End Of Cooking - Whirlpool OAKZ9 379 P IX Guía Rápida

5. END OF COOKING

An audible signal will sound and the display will
indicate that cooking is complete.
Press to continue cooking in manual mode (without
a programmed cooking time) or turn the adjustment
knob to extend the cooking time by setting a new
duration. In both cases, the temperature or the grill
level settings will be retained.
BROWNING
Some functions of the oven enable you to brown the
surface of the food by activating the grill once cooking
is complete.
When the display shows the relevant message, if
required press to start a five-minute browning cycle.
Once the browning function has been activated, you
can change the time for which it will run by turning the
adjustment knob. You can also stop the function at any
time by turning the selection knob to select a different
function or by turning it to
.
TIMER
When the oven is switched off, the display can be used
as a timer. To activate this function, make sure that the
oven is switched off and turn the adjustment knob: The
icon will flash on the display.
Turn the adjustment knob to set the length of time you
require and then press
audible signal will sound and the display will indicate
once the timer has finished counting down the selected
time.
Please note: The timer does not activate any of the cooking
cycles. Use the adjustment knob to change the time set on
the timer; press to switch the timer off at any time.
to switch the oven off.
again to activate the timer. An
.
KEY LOCK
To lock the keypad, press and hold
same time for at least five seconds.
Do this again to unlock the keypad.
Please note: This function can also be activated during
cooking. For safety reasons, the oven can be switched off at
any time by turning the selection knob to
. AUTOMATIC CLEANING – PYRO
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished airing)
running the Pyro cycle.
Remove all accessories - including shelf guides - from
the oven before activating the function. If the oven is
installed below a hob, make sure that all the burners
or electric hotplates are switched off while running
the selfcleaning cycle. For optimum cleaning results,
remove excessive residuals inside the cavity and clean
the inner door glass before using the Pyro function.
We recommend only running the Pyro function if the
appliance contains heavy soiling or gives off bad odours
during cooking. Turn the selection knob to select the
automatic cleaning function.
PYRO
There are two self-cleaning cycles available: a complete
cycle and a quick cycle (ECO).
PYRO
Turn the adjustment knob to select the desired cycle
and press to confirm. The oven begins the self-
cleaning cycle, and the door locks automatically: a
warning message appears on the display, along with
a countdown indicating the status of the cycle in
progress.
Once the cycle has been completed, the door remains
locked until the temperature inside the oven has
returned to a safe level.
The display will then show the current time.
Please note: like with other manual, it is also possible to set
the end time for the automatic cleaning cycle.
EN
and at the
.