Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
5.1 INSTALLATION INSTRUCTIONS
BODY DISASSEMBLY
•
To fit these collar splitters, disconnect tool from air supply
•
Remove pin tail deflector 47.
•
Remove nose assembly, if fitted
•
Lubricate the collar splitter cam faces, bearing faces and any
moving parts with Moly Lithium Grease.
•
Holding the head piston with a 10mm A/F" Allen Key through
the back of the tool, tighten the collet adaptor onto the head
piston with a spanner.
•
Push the anvil adaptor over the collet adaptor and screw on.
Tighten with a spanner
•
Insert the assembled collar splitter into the anvil adaptor and
screw onto the end of the collet adaptor. Tighten the nose
retaining nut on the anvil adaptor with a spanner
•
To operate, push the collar splitter hard over the collar and
depress the trigger.
•
To cut 5/16" or 3/8" Avdelok® use 07220-03700 and 07220-03900 collar splitters respectively – no adaptor kit is required.
Fit Head Vice Jaw* to Head 63 and use soft jaws to hold the Head Vice Jaw in the inverted orientation.
•
Use Locknut Socket* to unscrew Locknut 38. If necessary, use a 10mm A/F Allen key to prevent rotation of Base Plate
•
32.
•
Remove Base Cap 31 and Gasket 36.
•
Remove Retaining Ring 25 and Silencer 37.
•
Push Base Plate 32 into Body 65 and remove Retaining Ring 24.
•
With Base Plate extractor* fitted to underside of Body 65, screw Locknut 38 onto Base Plate 32, extracting Base Plate
from Body. If necessary, use a 10mm A/F Allen key to prevent rotation of Base Plate.
Screw Piston Stop to underside of Air Piston 33 locate using M6 screws into base and screw on.
•
* Contained in Service Kit. For complete list see page 17.
It is necessary to remove these accessories for priming of the tool.
14
O R I G I N A L I N S T R U C T I O N
-
Publicidad
