Bite Magnetic Mount; Cleaning And General Care; Troubleshooting - Bushnell GOLF PRO X3 Manual De Instrucciones

BITE MAGNETIC MOUNT

The Pro X3 features a powerful BITE magnet incorporated into the right side of its housing, which allows the device to be
securely attached to a golf cart bar or frame.
WARNING: BITE FEATURE INCLUDED WITH THE DEVICE CONTAINS A NEODYMIUM MAGNET. MAGNETS
COULD AFFECT THE FUNCTIONING OF PACEMAKERS AND IMPLANTED HEART DEFIBRILLATORS. IF YOU
USE THESE DEVICES, KEEP A SUFFICIENT DISTANCE FROM THE MAGNET. ALSO, WARN OTHERS WHO WEAR
THESE DEVICES FROM GETTING TOO CLOSE TO MAGNETS.
• The magnet may permanently lose part of its adhesive force if exposed to
temperatures above 175º F (80º C).
• Magnets produce a far-reaching, strong magnetic field. They could damage
TVs and laptops, computer hard drives, credit and ATM cards, data storage media,
mechanical watches, hearing aids, and speakers. Keep the unit away from devices
and objects that strong magnetic fields could damage.
• Magnets have strong magnetic fields which can pinch skin and fingers. Use
caution when attaching the unit to a metal bar.

CLEANING AND GENERAL CARE

Your Bushnell Pro X3 laser rangefinder lenses are fully multi-coated for the highest light transmission. However, care must
be taken in cleaning the lenses. Follow these tips for proper lens cleaning:
• Blow away any dust or debris on the lens (or use a soft lens brush).
• To remove dirt or fingerprints, clean with the supplied microfiber cloth rubbing in a circular motion. A coarse cloth
or unnecessary rubbing may scratch the lens surface and cause permanent damage. The included washable
microfiber cleaning cloth is ideal for routine optics cleaning. First, breathe lightly on the lens to provide slight
moisture, then gently rub the lens with the microfiber cloth.
• For a more thorough cleaning, photographic lens tissue and photographic-type lens cleaning fluid or isopropyl
alcohol may be used. Always apply the fluid to the cleaning cloth – never directly on the lens.
• The rangefinder is water-resistant but should not be exposed to heavy rain or other direct streams of water and will
not withstand submersion in water or other liquids.
CAUTION: Use caution to avoid direct sunlight into the eyepiece to prevent damage to the display/internal components.
When using the BITE magnet to attach the device to a cart bar or frame, tilt the device so the eyepiece aims towards the
ground, not toward the sun. When you are not using the device, please store it in the case for additional protection.

TROUBLESHOOTING

Never disassemble your laser rangefinder. Irreparable damage can result from unauthorized service attempts, voiding the
warranty.
If the unit does not turn on, the display does not illuminate:
• Press Power/Fire button.
• Check and, if necessary, replace the battery. If the unit does not respond to button presses, replace the battery with
a good quality CR2 3-volt Lithium battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a new 3 -volt lithium battery (CR2).
If the target range cannot be obtained:
• Make sure the display is illuminated.
• Make sure that the Power/Fire button is being pressed.
• Ensure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that
emit and receive the laser pulses.
• Ensure the unit is held steady while pressing the Power/Fire button.
NOTE: The last range reading does not need to be cleared before ranging another target. Aim at the new target using the
display reticle, press the Power/Fire button, and hold until new range reading is displayed.
Click to Return to the Table of Contents
8