Entering The Date And Time; Editing Default Values - Waeco ASC 6300 G LE Instrucciones De Uso

9. Press STOP .
The volume chosen is active and the standby menu is displayed.
12.6 Entering the company data
The company data is printed out with every service log.
1. In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER
3. Use the cursor key
4. Press ENTER
5. Enter the password
The company data is shown in the third line of the display.
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the message Enter company data (01 to 05).
Use the cursor keys
6. Use the keypad and the cursor keys to enter the data. To switch between upper and lower case, press the
key. To delete a character, briefly press the
key.
7. Press ENTER
8. Press STOP .
The set data is activated.
9. Press STOP
again.
The standby menu is displayed.
12.7

Entering the date and time

Date and time are required for logging of the service procedures. The date and the time are printed along with the
company data on every service log.
1. In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER
3. Use the cursor key
4. Press ENTER
5. Enter the password
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER
8. Press STOP .
The standby menu is displayed.
12.8

Editing default values

The A/C service unit has preset values for the most important service tasks. The default values appear
automatically when you select the respective menu.
You can alter the following default values if necessary:
to confirm.
to select Service.
to confirm.
.
3282
or to select the line of company data you want.
to confirm.
to confirm.
to select Service.
to confirm.
.
8463
to confirm.
or to select Other selections.
C
key. To delete the current line, press and hold down the
or to select Other selections.
EN
C
13