cecotec BOLERO DRESSCODE 2000 AUTODOSIS Manual De Instrucciones página 62

ENGLISH
- If you want to install a washing machine and a dryer in the same place, the front of the
compartment or cupboard must have an opening of at least 550 mm, without obstacles. A
washing machine alone does not require a specific ventilation opening.
Note:
- Do not install the washing machine on an unsteady platform.
- Do not install the washing machine in an area in which water could freeze. It can damage
the washing machine condition.
Step 3. Feet adjustment
Place the washing machine on a solid and level surface (if necessary, use a level).
If the floor is uneven, adjust the 4 adjustable feet as necessary; do not insert unstable items
under the washing machine to level it.
1. Take the spanner and loosen the nut clockwise. Fig. 6
2. Select the feet height and fix them by turning them clockwise to lift them and
counterclockwise to lower them. Fig. 7.
Important
Turn the nut counterclockwise. Fig. 8
Step 4. Water supply hose connection
1. If the hose is not installed, tighten it to the washing machine.
2. Tighten the inlet tube to the tap by hand with the spanner by tightening the nut. Fig. 9
3. Open the tap, after connection, to check if there are any leaks.
Warning
- Check the hose is not twisted or stretched.
- Do not place the draining hose in a bucket or bathtub.
- Check regularly if the inlet hose is broken or cracked. If so, replace it if necessary.
Step 5. Draining hose connection. Fig. 10
1. Connect the draining hose to a draining pipe.
2. Place the U-shaped elbow, if it is not installed, in the end of the draining hose.
Warnings
- Make sure the draining hose is not twisted.
- Secure the hose so it does not fall. After the washing phase, the washing machine will
drain the hot water.
- To make an extension use a hose of the same type and secure the connections with clips.
62