Filling With Water - Honeywell CO70PE Manual De Instrucciones

USE & OPERATION (CONTINUED)
REMOTE CONTROL (CONTINUED)
• Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
• Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product.
Please refer to the COOLER LOCATION (IMPORTANT TO READ) section of the separate Safety &
Maintenance Guide.

FILLING WITH WATER

It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time
without refilling the tank. This also helps prevent pump failure in case the cooler is running with
inadequate water in the tank.
CAUTION:
Unplug the unit from the electrical power outlet before filling or emptying the water tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is connected to a main water supply.
Note: The garden hose is not included. Please make use of a garden hose which is compatible with
the unit connection.
• Locate the male connector at one end of the garden hose. Insert the garden hose connector into
the water inlet valve of the cooler. Screw and tighten the water inlet valve onto the threaded part
of the garden hose connector, making sure the hose connector is secured to ensure there will be
no leaks. If there is leakage, the hose and the water inlet valve may not be connected properly. Try
to disconnect, replace and tighten the water inlet valve again.
• When the connection is secured, turn ON the water supply and the
water will flow into the water tank of the cooler.
• The cooler is now set so the water refills automatically.
• When the water tank is full, the water inlet valve will
automatically stop the water supply from overflowing.
WARNING: The maximum water inlet pressure is 0.5 MPa.
EN 5
Water
Inlet Value
Garden Hose