Publicidad
Idiomas disponibles
Idiomas disponibles
INTERSTELLAR-600
USER GUIDE
FX SEND / RETURN - A serial effects loop is provided at a level of 0dB. The
EFFECTS SEND socket can also be used as a Line Out socket if required
as the signal path through the preamp is only broken when a jack plug is
inserted into the EFFECTS RETURN socket.
The EFFECTS SEND is situated after the EQ, the Valve section the
Compression and the Sub Bass Processor.
SPEAKER OUTPUT - The Interstellar-600 has one power section rated at
600 Watts RMS with two Neutrik combi speakon out-puts. You can either
use Speakon or Jack Speaker cables to connect to your cabinet. Each Power
section has a minimum load of 4 ohms.
DIRECT INJECT (D.I.) - A balanced D.I. Is provided on a latching XLR socket.
The output signal from this XLR socket is set to a level and impedance
suitable for connecting directly into the Microphone input of a mixing desk
for either Direct Injection into the PA system or for recording. This must
ONLY be used into a Balanced Microphone input, it is not intended for any
other type of connection.
This has a floating ground that is referenced to the mixing console it is
plugged into and should not need ground lifting. It is also unaffected by
Phantom Powering on the Microphone input.
Make sure your XLR plug does not have the shell of the plug internally
connected to signal ground or this will connect the system to chassis ground
of the INTERSTELLAR-600 and may cause problems with hum.
Publicidad
