Descargar Imprimir esta página

Columbus Kamado Manual De Uso página 39

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly instructions
IMPORTANT - Remove any packaging before use, but retain the safety instructions and store them with this product.
IMPORTANT - Remove any packaging before use, but retain the safety instructions and store them with this product.
Untergestell:
Ensure that the lid is closed prior to assembly.
Ensure that the lid is closed prior to assembly.
4
2
F
SCHRITT 1 - Befestigen Sie die obere (4 und 5) und die untere
Position the parts on a flat surface that will not scratch the finish of the nest components, paying close
attention to the joint overlap in illustration the 2pcs Upper cross brace(4&5) and 2pcs Lorer cross brace(2&3).
STEP 1 -
Verbindungsleiste (2 und 3) mit den mitgelieferten Schrauben (A) und Muttern
Using the given hardware and hand tighten the braces with screw A + nut F.
(F), wie in der Abbildung oben dargestellt. Ziehen Sie die Schrauben von Hand
Assembly instructions
Assembly instructions
an.
1
C
H
G
8
(Joining the two halves assembled in step l) Stand the section 1 upright, and place the upper cross
SCHRITT 2 - Befestigen Sie die oberen Verbindungsleisten (4 und 5)
STEP 2 -
braces (4&5) close to section 1. Inserting truss head screw C through the hole of section1
an den Beinen des Fahrgestells, indem Sie das Bein (1) mit den oberen
and section 4&5 and install K Keps nut and tighten securely.
Verbindungsleisten mit Schraube (C) und Mutter (J) verbinden, wie in der
(Installing the lower cross braces and casters) Place the assembled lower cross braces (2&3) under section 1,
obigen Abbildung gezeigt. Ziehen Sie die Schrauben von Hand an.
Stand the section 6 upright to make it close to section 1 and secrion 4&5. Inserting screw B through
STEP 3 -
section 4&5 and section 6, install G Keps nut and tighten securely.Next insert the threaded caster stem
through the hole in the end of the lower cross brace then through the riser and finally the riser brace.
Install (H) flat washer and (I) Keps nut, repeat this at the remaining (3) aster locations and securely tighten.
J
39
DE
A
5
3
5
B
4 und 5
F
6
2 und 3

Publicidad

loading