Publicidad
Idiomas disponibles
Idiomas disponibles
(Joining the two halves assembled in step l) Stand the section 1 upright, and place the upper cross
STEP 2 -
PASO 3 - Coloque el listón de refuerzo (6) en el interior de la pata (1) y
braces (4&5) close to section 1. Inserting truss head screw C through the hole of section1
and section 4&5 and install K Keps nut and tighten securely.
conéctelo al listón de unión superior con el tornillo (B) y la tuerca (F). Apriete a
mano. Fije las tiras de conexión inferiores colocándolas contra la parte inferior
(Installing the lower cross braces and casters) Place the assembled lower cross braces (2&3) under section 1,
de la pata (1). Pase la rosca de la rueda giratoria a través de las tiras de conexión
Stand the section 6 upright to make it close to section 1 and secrion 4&5. Inserting screw B through
STEP 3 -
section 4&5 and section 6, install G Keps nut and tighten securely.Next insert the threaded caster stem
inferiores (2 y 3), la pata (1) y la tira de refuerzo (6). Asegure con el anillo de
through the hole in the end of the lower cross brace then through the riser and finally the riser brace.
seguridad (G) y la tuerca (H). Apriete a mano.
Install (H) flat washer and (I) Keps nut, repeat this at the remaining (3) aster locations and securely tighten.
8
STEP 4 -
As picture, put wheels 7 in front, and wheels with brake at the back.
PASO 4 - Repita el paso 3 para las otras 3 patas. Coloque las ruedas giratorias
STEP 5 -
To place the Oven on the cart first remove all of the items that are inside of the grill to make lifting easier.
con freno (8) en la parte trasera, las ruedas giratorias sin freno (7) en la
Use a minimum of two people when lifting the Oven onto the cart. Place one of your hands in the bottom
parte delantera. Ahora apriete todos los tornillos, pernos y tuercas con la
STEP 6 -
vent of the Oven and the other under the grill. Lifting by the hinge or the side tables could result in injury
herramienta.
and damage to the product.
Position the nest upright on a flat level surface with the help of an assistant you can now place the oven
STEP 7 -
PASO 5 - Retire todas las piezas sueltas de la Kamado (12).
into the nest. Position the oven so the vent door is accessible between two of the risers and gently push
downward on the oven to seat it in the nest.
61
ES
7
Publicidad
