Descargar Imprimir esta página

Additional Information In The Welding Report; Entering Preformatted And User-Defined Traceability Data; Entering Or Changing The Job Number And Joint Number - HURNER HST 300 Print+ 2.0 Manual De Instrucciones

Ocultar thumbs Ver también para HST 300 Print+ 2.0:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 59
needed, browse to the welding abstract of the joint that
needs to have its geo-data assigned. Then press the ñ
cursor key in the ViewWeld screen displaying the desired
welding operation. This causes a screen asking you if you
want to record geo-data to appear (see Display 12). Con-
firm by pressing the START/SET key and log the geo-data
according to the procedure described in Sect. 6.7.
6

Additional Information in the Welding Report

Every welding report saved to system memory, which can
be downloaded as a PDF report file or in the DataWork
format, contains a number of welding and traceability data
that the operator can decide to enter or not to enter in
the set-up menu.
6.1 Entering Preformatted and User-defined
Traceability Data
All traceability data enabled in the configuration menu at
"Data Recording" (see Sect. 10) have to be entered before
the welding process. The welding unit prompts the user to
enter them either before or after entering the fitting bar
code (see Display 2). Depending on what data is entered,
either its repeated input is mandatory (e. g., the welder
ID code; see Sect. 5.2) or previously entered data can be
changed and confirmed or confirmed without changes
(e. g. the commission number; see Sect. 6.2).
Certain traceability data can also be accessed quickly, via
a selection screen, by pressing the ï cursor key (see Dis-
play 7), either for viewing or for entering or changing/
confirming them (for the AutoWeld feature mentioned
along with them on this screen, see Sect. 5.5).
6.2
Entering or Changing the Job Number and Joint
Number
The commission number input screen is shown by the unit
before welding or accessed by the user in the quick access
screen (Display 7). It can be entered using the alphanumeric
keypad (see Info in Sect. 5.2) or by reading it from a bar
code using the scanner. The maximum length is 32 char-
acters. Confirm your input by pressing the START/SET key.
The job number will be saved to memory and will appear
in the printed welding report.
Provided is was enabled in the configuration menu (see
Sect. 10.2), a commission number-related joint number is
also recorded and shown along with the report number
14
EN
HÜRNER HST 300 Print + 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
***
Recording
AutoWeld
>Welder ID Code
Enter Job No.
Enter Job No.
********************
************
Version September 2022
****
Display 7
Display 8

Publicidad

loading