Charger Location; Battery Charging - Ac Connections - Schumacher Electric CR1 Manual Del Usuario

3.4 Read, understand and follow all instructions for the charger, battery, vehicle and any
equipment used near the battery and charger. Study all of the battery manufacturer's
specific precautions while charging and recommended rates of charge.
3.5 Determine the voltage of the battery by referring to the vehicle owner's manual and
make sure that the output voltage is correct.
3.6 make sure that the charger cable connector makes a tight connection.
4.

CHARGER LOCATION

corrode and damage the charger.
4.3 Do not set the battery on top of the charger.
4.4 Do not operate the charger in a closed-in area or restrict the ventilation in any way.
5. BATTERY CHARGING - DC CONNECTIONS
5.2 When disconnecting the charger, disconnect the AC cord and then remove the
connector from the battery.
5.3 Do not face the battery when making the final connection.
6. BATTERY CHARGING – AC CONNECTIONS
6.2 Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper
grounded outlet installed by a qualified electrician. An improper connection can result in
a risk of an electric shock or electrocution. NOTE: Pursuant to Canadian Regulations,
use of an adapter plug is not allowed in Canada. Use of an adapter plug in the United
States is not recommended and should not be used.
6.3 Recommended minimum AWg size for extension cord:
• 100 feet (30.5 meters) long or less - use an 18 gauge (0.82 mm
• Over 100 feet (30.5 meters) long - use a 16 gauge (1.31 mm
7. FEATURES
RISK OF ELECTRIC SHOCK OR FIRE.
6.1 This battery charger is for use on a nominal 120-volt circuit.
The plug must be plugged into an outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
The plug pins must fit the receptacle (outlet). Do not use with an
ungrounded system.
2
RISK OF EXPLOSION AND CONTACT WITH
BATTERY ACID.
4.1 Locate the charger as far away from the
battery as the DC cables permit.
4.2 Never place the charger directly above the
battery being charged; gases from the battery will
A SPARK NEAR THE BATTERY MAY CAUSE A
BATTERY EXPLOSION. TO REDUCE THE RISK
OF A SPARK NEAR THE BATTERY:
5.1 Connect and disconnect the DC output
connector only after removing the AC plug from the
electrical outlet.
1. LED Display
2. Quick-Disconnect Cable
3. Automatic voltage Detection
4. Thermal Runaway
1
3
• •
) extension cord.
2
) extension cord.
2