Control Panel - Schumacher Electric CR1 Manual Del Usuario

8. ASSEMBLY INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the battery charger.
9.

CONTROL PANEL

LED Display
A.C. POWER
charger.
CHARGING
CHARGING
CHARGED
is in maintain mode.
CHARGED
"ready to use".
NOTE: See the operating Instructions section for a complete description of the charger
modes.
10. OPERATING INSTRUCTIONS
assembly instructions before it is used.
Charging
1. Disconnect the vehicle's wiring harness to remove the battery. Examine the battery
for excessive wear, cracks, bulging or damage each time you charge the battery. If
damage is detected, do not charge the battery, replace it immediately. If the battery is
hot, allow it to cool before charging.
2. Select the proper output cable by matching the output cable connector to the
vehicle's battery connector.
3. Connect the battery following the connection instructions described in Using the
Quick-Disconnect Cable Connectors section.
4.
Connect the AC power following the precautions listed in section 6.
5. If you've connected everything correctly, the ChARgINg
indicating that the charger is charging.
Using the Quick-Disconnect Cable Connectors
Connect the output cable assembly to the charger. make sure to place the charger on a
dry, non-flammable surface like metal or concrete.
• With the charger disconnected from the wall outlet, connect the supplied harness
assembly by connecting the black connector to the black connector on the end of the
charger cable. Connect the other end of the cable assembly to the battery.
NOTE: See Replacement Parts for more connector information.
NOTE: Never connect the output cable assemblies together for use in other
applications, such as external battery or other power source charging, or to extend the
output cable length, as reverse polarity and/or overcharge conditions will occur.
Quick Charge
When the ChARgED
the charger from the wall outlet and then disconnect the charger from the battery. NOTE:
The ChARgINg
Complete Charge
When the ChARgED
LED turns off, the battery is completely charged and has stopped charging and switched
to the maintain mode of operation. When ready to use, unplug the charger from the wall
outlet and then disconnect the charger from the battery.
NOTE: for longer battery life, the battery must be completely charged after two
consecutive quick charges. (Example: quick-quick-complete.)
(red) LED lit: Indicates that there is AC power supplied to the battery
(yellow) LED lit: Indicates the charger is charging the battery.
(yellow) LED flashing: Indicates the charger is in abort mode.
(green) LED lit: Indicates the battery is fully charged and the charger
(green) LED flashing: Indicates the battery is 80% charged and is
This battery charger must be properly assembled in accordance with the
LED begins to flash, the battery is "Ready To Use". Unplug
LED will remain lit while the ChARgED
LED stops flashing and stays lit and the CHARGING
4
• •
LED should be lit
LED is flashing.