Remote Control - Faber T-Night Manual De Instrucciones

4. CONTROLS
Button Function
A Turns the motor on/off at speed one.
With the motor turned off:
Saturation of the grease filters takes place after 100 hours of continuous
operation of the hood.
With the motor turned off:
Saturation of the activated charcoal filters takes place after 200 hours of
continuous operation of the hood.
B
Turns the motor on at speed two.
Press and hold the button for approximately 2 seconds, with all the loads
turned off (Motor+Lights), to turn the Activated Charcoal Filter alarm on. LED
(A) flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 2 seconds.
The relevant LED flashes once (A).
C Turns the Motor on at speed three.
Press and hold the button for approximately 2 seconds, with all the loads
turned off (Motor+Lights), to reset the Filter saturation alarm. LED A flashes
three times.
D Turns the motor on at INTENSIVE speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with
the motor turned off, it will switch to OFF at the end of the time. To deactivate
it, press button D once more or press button A.
With all the loads turned off (Motor+Lights), press and hold D for
approximately 2 seconds to enable the remote control. Button A flashes twice.
With all the loads turned off (Motor+Lights), press and hold D for
approximately 2 seconds to disable the remote control. Button A flashes once.
E Turns the lights on/off at maximum strength.

5. REMOTE CONTROL

(OPTIONAL)
6
6. LIGHTING
• Lamps in risk group 1 under
IEC/EN62471 at a distance of
20cm and in exempt from risk
group under IEC/EN62471 at
a distance of 30cm.
• For replacement contact technical sup-
port ("To purchase contact technical
support").
Led
Fixed.
Flashes once a
second.
Flashes once
every 0.5
seconds.
On.
Flashing.
On.
Flashing.
Flashing.
Flashing.
On.