Remove The Roller; Assemble The Roller - Mowox PS 4015 P-N Manual De Instrucciones

Note
:

Remove the roller

1. There is a wrench in the back of the transport lever (fig. 9a).
2. Remove the two screws holding the roller's axle using the wrench (fig. 9b).
3. Lift the roller up a bit and pull it out in the direction of the arrow (fig. 9c).
Fig. 9a

Assemble the roller

1. Slide the new roller in the direction of the arrow, insert the shaft into the hexag-
onal socket and press the opposite side into the holder (fig. 9c - e: Scarifier roller,
fig. 9f –h: Aerator roller).
2. Refasten the roller with the two screws.
3. Check that the roller is seated correctly.
Do not lift too high, fuel may run out of the tank.
Wrench
20
Fig. 9b
Fig. 9c
(EN)