Maintenance And Cleaning; Problem Solving - Mx Onda MX-PIP2199 Manual De Instrucciones

MAINTENANCE AND CLEANING

Before cleaning disconnect the unit from the mains power supply. And make
sure the plate is completely cold. Do not use alcohol or abrasive products and
not allow the appliance to contact volatile agents such as gasoline, solvents,
insecticides, etc.
Cleaning the cooking plate
•
After each use you should clean the plate, thus it will prevent burning
remains attached.
•
Do not clean the plate until it is cold enough.
•
Use only specific products for cleaning induction plates, failure to do so
could damage the cooking surface.
•
Never use scouring pads that may scratch the surface, nor should use
abrasive cleaning fluids how sprays for furnaces.
Cleaning the plastic surface
•
Clean the plastic surface with a damp cloth and then with a dry one. Avoid
water from the vents.
•
If you see the holes in the fan has accumulated a lot of dirt, remove it with
a brush.

PROBLEM SOLVING

If there is any abnormality or problem in the operation of the induction hotplate,
the display 4 or 13 show the detected error of the corresponding cooking zone.
Error messages appear on the screen with the letter " E " followed by a number,
see the table below to identify the error and solution.
Message
No container, the container is not
E0
suitable for induction or the diameter
of its base is less than 12 cm
E2
The NTC sensor is defective
Undervoltage protection
E3, E4
or overvoltage portection
The glass or ceramic plate has
E5
overheated
E6
It is activated overheating protection
Description
Place a container on the cooking zone or
replace the container that is invalid.
Contact our Customer Service nearest MX
ONDA.
If the voltage at the outlet network is less
than or greater than that specified, consult
a qualified electrician.
Unplug the induction plate and allow to
cool.
Failure in the ventilation system, check that
the fan is not clogged and functioning
properly. Unplug the induction plate and
allow to cool.
13
Solution