Wire Rack Positions; Replacement Of The Oven Lamp - ICQN MGA1-8 Serie Manual De Instrucciones

Wire Rack Positions

Rack 6
Rack 5
Rack 4
Rack 3
Rack 2
Rack 1
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure,
first remove the lower, and than the upper side from installation location.
To install wire racks; reverse the procedure for removing wire rack.

Replacement Of The Oven Lamp

WARNING: Disconnect power supply and wait for the oven to cool down
to eliminate the risk of electrocution before replacing the oven lamp. Hot
surfaces may cause burns.
Remove the glass protector by rotating it. Using plastic gloves may help
you if you have difficulty in rotating it.
Then, remove the lamp by rotating it, and install the new lamp with the
same specifications. Replace the glass protector, plug the appliance and
complete the replacement procedure. You may now use your oven.
Type G9 Lamp
220-240 V, AC
15-25 W
Figure 79
It is important to place the wire
grill into the oven properly.
Do not allow wire rack to touch
rear wall of the oven.
Rack positions are shown in the
next figure.
You may place a deep tray or a
standard tray in the lower and
upper wire racks.
Type E14 Lamp
55
220-240 V, AC
15 W
Figure 80