Overhang; Adjusting Buckle Position - Britax GROW WITH YOU CLICKTIGHT Guia Del Usuario

Britax Child Safety, Inc.
In some cases, the vehicle head restraint
can prevent the child seat head restraint
from being raised high enough to
properly adjust the harness for the fit
of your child. DO NOT force the child
seat head restraint past the vehicle head
restraint. Doing so could cause the child
seat not to perform as intended. If the
location of the vehicle head restraint interferes with the
child seat head restraint, raise or remove the vehicle head
restraint. If the vehicle head restraint cannot be removed,
move the child seat to the upright position or try a different
seating location.

Overhang

Harness Mode
It is important that the base of the child seat rests
completely flat on the vehicle seat with no side overhang.
It is permissible to allow up to 3 in. (7.6 cm) of the base to
hang over the front edge of the vehicle seat. If the vehicle
seat does not allow enough of the child seat base to make
contact, adjust the recline angle to a more upright position.
Not doing so could cause the child seat to not perform as
intended.
Booster Mode
Overhang is not allowed in booster mode. In booster mode,
the base of the child seat must fit completely on the vehicle
seat.

Adjusting Buckle Position

Removing the Buckle
1. Unbuckle the harness by
pressing the release button
and pulling the tongues.
22 22
WARNING!
Harness Mode
3 in
Booster Mode
Table of Contents