Publicidad
Idiomas disponibles
Idiomas disponibles
Lubrication frequency:
For
optimal
recommends the use of it´s own
brand silicone-based lubricant.
As
a
general
recommends lubricating the belt at
least
once
approximately every 30 hours of
use (whichever happens first).
Use in very dry, hot or dusty
environments, by heavy people
and/or walking regularly at a slow
pace (<5km / h) increase the need
for lubrication. Depending on the
case, it may be necessary to
lubricate every fifteen days or even
every week.
Using another brand lubricant or
another type of lubricant may
require more frequent lubrication,
and may even damage the belt
and/or the board and cause motor
and other parts failure.
5 ADJUSTING THE BELT.-
CAUTION:
Before
machine, turn it on and check that
the belt is centered. If necessary,
follow the steps below.
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways.
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt,
set the unit in motion at a speed of
4km/h. If the belt has moved to the right,
turn screw (R) on the right-hand side of
the machine a 1 4 turn clockwise. Note
the position of the belt, if after one minute
the belt is not completely centred then
repeat the operation. If you see that the
maintenance,
guideline,
a
month
using
belt has moved too far over to the left
then turn the right screw back slightly in
BH
an anticlockwise direction. Fig.6.
As soon as you have adjusted the belt
you can begin exercising again.
BH
BELT OFFSET TO THE LEFT.-
or
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1 4 turn clockwise.
Note the position of the belt, if after one
minute the belt is not completely centred
then repeat the operation.
If you see that the belt has moved too
far over to the right then turn the left
screw back slightly in an anticlockwise
direction. Fig.6.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt
itself. Bear In mind that one turn of the
right screw (R) in a clockwise direction
has the same effect on the position of
the belt as one turn of the left screw (L)
in
an
the
Consequently,
excessive belt movement you can use
either of the two screws in order to
avoid overtightening the belt.
FOLDING YOUR UNIT.-
This treadmill is equipped with a
folding
purposes. To use it, stop the treadmill,
lower the elevation level to minimum,
unplug the mains cable.
Lower the monitor so that it is parallel
with the tray, Fig.7, I. Press the
buttons (B) located on the top of the
posts and lower the tray as shown in
Fig.7, II. Step on the folding rod (39)
and lower the posts, Fig.7, III. Remove
cable, remove brackets (45) and lift
the unit, Fig.7, IV, V.
19
anticlockwise
in
the
mechanism
for
direction.
event
of
storage
Publicidad
