Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
WARNING
Prior to operating your tiller, carefully read and follow all instructions
below. Perform all adjustments to verify your tiller is operating safely
and properly.
Depth Stake & Wheels
The tiller is shipped with the wheels adjusted so that the machine sits
level. The wheels need to be adjusted to meet your tilling needs before
operation. This adjustment is made by removing the clevis pin from the
wheel yoke and raising the wheels to the desired height. See Figure 9.
Wheel Yoke
Cotter
Pin
ASSEMBLY
Clevis
Pin
Depth
Stake
Figure 9
Clutch Cable Adjustment
Before operating the tiller the adjustment of the forward clutch cables
must be checked.
1.
Disconnect and ground the spark plug wire against the engine.
2.
Adjust the forward clutch cable by loosening the hex nut. See
Figure 10.
Cable Collar
3.
Turn the cable collar section one or two turns to increase or
decrease tension on the cable. See Figure 10.
4.
Retighten the lock nut against the cable collar. See Figure 10.
5.
With the forward tine engagement handle in the neutral — re-
leased — position, pull the starter rope several times. The tines
should not turn.
6.
If they turn adjust the forward clutch cable to release tension
using the previous steps in this section.
7.
Check again for correct tension on the cable.
8.
After tilling, if the tines stop moving, re-adjust the cables.
10
Hex Nut
Figure 10
Publicidad
Solución de problemas
