Before Use - cecotec CONGA 999 VITAL X Manual De Instrucciones

ENGLISH
5. Direction buttons
6. Spot cleaning
7. Room cleaning
8. Scrubbing levels
9. Scheduling
10. Edge cleaning
11. Power levels

2. BEFORE USE

- Take the product out of the box.
- Remove all packaging material. Save the original box.
- Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact the Cecotec official Technical Support Service
immediately.
- Warning: remove all objects around the robot such as clothing, papers, cables, curtains or
other fragile objects. Fig. 16
- If the room to be cleaned is near a balcony or stairs, a physical barrier must be placed in
order to prevent product damage and ensure safe operation. Fig. 17
- Direct exposure to sunlight or great light contrasts may affect the correct operation of
the sensors. If this happens and the robot stops, change it to a new location for it to start
operating again.
1. Place the charging base against the wall and leave a minimum free space of 2 metres to
the front and 1 metre to each side. Fig. 18
2. Connect the charging base to a power socket. Wind and store the remaining cable in the
lower part of the charging base to prevent accidents. Fig. 19
3. Install both side brushes in their corresponding slots, located on the robot lower part.
Press until they click to make sure they are properly fixed. Fig. 20
4. Press the power switch located on the lower part of the robot. Make sure the power
switch is in the I position. Fig. 21
5. Place the robot on the charging base and make sure the charging terminals on the robot
match those of the charging base. Once the robot is properly placed, it will beep once and
the power button will light up. If the light is oscillating orange, it means the battery is not
completely charged. To ensure maximum cleaning time, wait until the light switches to
steady blue. This will indicate the battery is fully charged and the robot is ready to clean.
Fig. 22.
34