cecotec CONGA 999 VITAL X Manual De Instrucciones página 39

Recommendations:
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. You can also use warm water without detergents to obtain better results.
Always make sure they are completely dry before installing them again; otherwise, moisture
can reach the robot motor and damage it.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to thoroughly clean edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours or less.
Recommendations:
It is recommended to clean the side brushes once a week with the help of the cleaning brush.
Main brush and silicone main brush
The main brush is designed with bristles and silicone, spins at top speed and helps introduce
dirt into the suction nozzle. This brush is in contact with the floor, and therefore with dirt, so it
can be worn out over time, affecting negatively to the cleaning efficiency. For this reason, it is
suggested to replace the main brush after a maximum of 320 hours or less.
Recommendations:
- It is recommended to clean the main brush once a week with the help of the cleaning brush.
- Follow the same recommendations with the silicone main brush.
Sensors
The robot vacuum cleaners have different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles or free-fall sensors that help
the robot detect slopes or possible gaps/unevenness such as staircases. These sensors are
always in contact with dust particles, and therefore can be blocked over time, causing possible
navigation errors. It is suggested to clean all the robot's sensors with the cleaning brush or
with a dry cloth after a maximum of 35 hours of operation or less.
Battery charge and replacement
1. To lengthen the battery shelf life, keep the robot charging on the charging base when not
in use.
2. If the robot will not be used for a long period of time, remove the battery from the product
and store it in a dry and safe place.
3. To replace the battery, follow the instructions below:
4. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig.
41
5. Insert the new battery with the battery label facing up. Fig. 42
6. Place the battery and the battery cover in its place and properly fix the screws back again.
ENGLISH
39