Stopping The Generator - WARRIOR 6500SV Operating Manual

WPE DIESEL GENERATORS
10. Never switch between position 1 or 2 whilst
equipment is plugged in, always disconnect
equipment before changing voltage.
11. When not in use always turn the switch to '0' and
disconnect equipment or push circuit breaker to
'OFF' position.
DC Operation
The DC terminal may be used for charging 12V
automotive type batteries only.
1. When using automotive-type batteries with battery
cables, be sure to disconnect the minus pole battery
cable from the battery before charging.
2. Start the engine.
3. Connect the charging cable to the battery terminals
and the DC terminals of generator.
Connect the positive battery terminal to the positive
generator terminal. Do not reverse the charging
cables, or serious damage to the generator and/or
battery may occur.
Do not allow the free ends of the cable to touch each
other. If this occurs, it will be short circuit the battery
When a large capacity battery is charged, excessive
current flows(the value varies depending on the
discharging condition) , and the fuse for the direct
current will blow.
4. Batteries produce explosive gases. Keep sparks,
flames and cigarettes well away. To prevent the
possibility of creating a spark near the battery,
always connect the charging cables to battery first
and only then to the generator. When disconnecting,
you should disconnect the cables at the generator
first.
5. Charge the battery in a well ventilated place. Before
charging, remove the cap from each cell of the
battery. Discontinue charging if the electrolyte
temperature exceeds 45°C.
WARNING

Do not attempt to start an automobile engine while
the generator is still connected to the battery.
NEVER try to use both DC 12 volt and AC at the same
time.

Stopping the generator

1. Turn off the AC circuit breaker.
2. Leave the engine speed lever in the "RUN" position,
operate the engine without load for approx 3 minutes,
DO NOT stop the engine suddenly because this may
cause the temperature to rise abnormal and cause
the nozzle to damage and seize the engine.
3. Push down the stop lever or Turn the ignition key
anticlockwise to "OFF" position .

If the engine keeps on running even after the speed
lever is pressed at the "Stop" position, turn the
ignition key to 'OFF' position. NEVER try to stop the
engine with the decompression lever (Open Frame
Type Only)
MAINTENANCE
Periodic check and maintenance are very important for
keeping the engine in good condition. Please read the
detailed description of operating manual for each part.
Shut off the engine before performing any maintenance.
If the engine must run, make sure the area is well
ventilated. The exhaust contains poisonous carbon
monoxide gas.
After the engine has been used, clean it immediately with
a cloth to prevent corrosion and remove sediment.
Recommended Engine Oil Type
5W-30
°F -20 0 20
°C -28.9 -17.8 -6.7
DAILY
— Check oil level
— Check and replenish fuel
— Check for oil leakage
— Check and tighten and engine parts if loose
FIRST 20 HOURS
— Change oil
— Drain fuel tank
— Adjust valve clearance for intake & exhaust
valves*
— Lap intake & exhaust valves*
MONTHLY
— Check battery fluid
— Check air filter
8
MAINTENANCE
WARNING
10W-30
10W-40
5W-30 Full Synthetic
40 60 80 100
4.4 15.6 26.7 37.8
Ambient temperature
120
48.9