Starting / Stopping The Engine - Stihl FC-MM Manual De Instrucciones

Mounting the MultiTool
The direction of rotation is marked
with arrows on the gearbox and
blade. Make sure the arrows point in
the same direction.
8
8
4
5
4
: First fit the two sleeves (4) on the
right and left.
: Rotate the blade (5) on the right-
hand shaft (viewed from engine)
until it can be pushed into position –
check the direction of rotation again
(arrows).
: Push the wheel (6) and washer (7)
on to the left-hand shaft (viewed
from engine).
: Insert and engage hitch pins (8) in
the holes in the ends of the shaft –
fold the hitch pins flat against the
blade and wheel.
FC-MM
Starting / Stopping the
Engine
6
Starting
: Secure the handlebar in the
operating position.
7
: Retract the wheels, if fitted – see
notes on "Wheels" in the
MultiEngine instruction manual.
: Place the unit on a patch of clear
ground. It must rest securely on the
engine flange and the support on
the frame. Check that the working
tools are not touching the ground or
any other obstacles.
Make sure you have good balance
and secure footing – as shown in
the illustration. To reduce the risk of
injury from contact with rotating
attachments, always stand to the
side of the power tool, never in front
of or near the attachments.
English / USA
: With your left hand on the loop
handle, press the unit firmly against
the ground.
Do not stand or kneel on the
handlebar or frame.
The starting procedure is now as
described in the MultiEngine instruction
manual.
To shut down the engine
: Push slide control in direction of
arrow ( h ) to STOP – $.
15