Auto Hold-Log Operation - Keysight Technologies U1231A Guia Del Usuario

Auto Hold-Log operation

Pressing the
Figure 3-6
– The Auto Hold-Log operation monitors the input signal and updates the
NOTE
– The
Press and hold
Changing the default Auto Hold-Log variation count
1 Press and hold
2 Ensure that the
3 Press
4 Press
If the reading value is unable to reach a stable state (when exceeding the preset
NOTE
variation), the reading value will not be updated.
Keysight U1231A, U1232A, and U1233A User's Guide
for more that 1 second activates the Auto Hold-Log function.
Auto Hold-Log display
display and, if enabled, emits a beep whenever a new stable measurement is
detected. The multimeter is ready to update the display once the variation of
the reading exceed the setting of the variation count.
annunciator will flash while attempting to acquire a stable
reading.
for more than 1 second to exit this mode.
menu.
or to edit the variation count value shown on the display.
Max
Min
to save the changes. Press and hold
restarts.
while powering on the multimeter to enter the Setup
annunciator is shown on the display.
Multimeter Features
until the multimeter
3
93