Steam Function - Krups F 927 Instrucciones De Uso

Notes :
. To obtain a shorter coffee, it is possible to
interrupt the automatic cycle at any time by
pressing the control (e6).
. To obtain a longer coffee, it is possible to
prolong extraction after the machine has
stopped automatically by holding down the
control (e6).

2. STEAM FUNCTION

With the auto cappuccino accessory (i), you
can :
. easily obtain more or less frothy milk to
make a cappuccino, a café crème or a hot
chocolate.
. heat thick liquids (for example soup).
Practical tips :
. Cappuccino : 1/3 coffee, 1/3 hot milk, 1/3
milk foam.
. Café crème : 1/2 coffee, 1/2 less foamy hot
milk.
. Hot chocolate: 1 cup of hot milk (more or
less foamy, depending on your taste) into
which you mix chocolate powder.
. Preparing steam function
• Fill the water tank (b).
• Press the control «
light will flash.
As soon as the appliance reaches the right
temperature, the indicator light of the control
(e2) stops flashing.
• Press the « » control (e4).
The indicator light of the "on/off" control (e2)
flashes.
a . Foaming milk :
• Pour the milk into the tank (i4). For best
results, use cold fresh whole or semi-
skimmed milk.
• Place the tank (i4) with its lid, on the support
(i5).
• Insert the flexible tube (i3) into the opening
in the lid of the tank. The tube must touch
the bottom of the container (8).
• Turn the tap (i1) to the position " " to
obtain a fine, smooth foam (9a).
• To obtain less frothy milk, turn the tap (i1)
towards the top of the scale (9b).
12
» (e2), and its indicator
• Place a cup under the nozzle (i2) (8). If
necessary, adjust the height of the grille
support (4).
As soon as the appliance reaches the right
temperature, the indicator light (e2) stops
flashing.
• Turn the function selector (d) to the « »
position until you obtain the required
quantity of foamy milk.
• Turn the function selector (d) to the «
position and remove the cup.
Note :
• Keep the tank (i4) containing any unused
milk in the fridge.
b. Heating thick liquids (e.g. soup):
• Turn the tap (i1) to the « » position.
• Immerse the nozzle (i2) in the liquid to be
reheated (10). If necessary,adjust the height
of the grille support (4). The tip of the
nozzle must not touch the bottom of the
container so as not to obstruct the passage
of the steam.
As soon as the appliance reaches the right
temperature, the indicator light (e2) stops
flashing.
• Turn the function selector (d) to the « »
position until the liquid is hot enough, then
reset the function selector (d) to the «
position and remove the container.
. Important notes :
• After using the steam function, press the
« » control (e4) to deactivate this function.
The appliance will cool itself down
automatically until it reaches the correct
temperature to return to the espresso
function.
• If you do not press the «
within about 2 minutes after using the
steam function, the appliance will cool itself
down automatically to return to the espresso
function.
• The intermittent noise produced during the
preparation of steam is caused by the pump
being regulated and has nothing to do with
the correct operation of the appliance.
• During and after operation of the appliance,
the nozzle (i2) is very hot.
• We would recommend that you clean the
auto cappuccino accessory immediately after
use (see "Maintenance" section).
»
»
» control (e4)