Warranty; Know Your Unit; Assembly Instructions - Craftsman WEEDWACKER 316.795861 Manual Del Operador

FOR 2 YEARS from the date of purchase, this product is warranted against any defects in material or workmanship. Defective product will receive free repair or
free replacement if repair is unavailable.
For warranty coverage details to obtain repair or replacement, visit the web site: www.craftsman.com
This warranty covers ONLY defects in material and workmanship. Warranty coverage does NOT include:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
• Product damage resulting from user attempts at product modification or repair or caused by product accessories.
• Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
• Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty is void if this product is ever used while providing commercial services or if rented to another person.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds
• Edging
• Decorative trimming around trees, fences, etc.
As a brushcutter:
• Cutting weeds and light brush of up to 1/2 inch in diameter
Other optional accessories may be used with this unit.
Brush Blade
Hassle Free ®
Cutting Head
INSTALL AND ADJUST THE D-
HANDLE
1. Remove the screws and
bottom clamp.
2. Place the D-handle over the
shaft housing and onto the
bottom clamp (Fig. 1). Move
it a minimum of 6 inches
(15.24 cm) from the end of
the shaft grip.
3. Start the screws with an
appropriate tool. Do not
tighten until making the
handle adjustment.
4. If pre-installed, loosen the screws just enough to move it.
5. While holding the unit in the operating position (Fig. 19), move the D-handle
to the location that provides the best grip.
6. Tighten the clamp screws evenly until handle is secure.
WARRANTY STATEMENT
CRAFTSMAN 2 YEAR FULL WARRANTY
Sears Brands Management Corporation, Hoffman Estates, IL 60179
Shoulder
Strap Clip
Convertible™
Coupler
Shaft Housing
Blade Shield /
Shield Mount
Line Cutting Blade

ASSEMBLY INSTRUCTIONS

Screw (4)
Barrier Bar
D-Handle
Minimum 6 in.
(15.24 cm)
Fig. 1

KNOW YOUR UNIT

Shaft Grip
On/Off
Control
D-Handle
Cutting Head Shield
NOTE: Make sure the barrier bar is on the operating side when the unit is
held in the operating position.
INSTALL CUTTING ATTACHMENT SHIELD
WARNING:
the unit without the cutting attachment shield in place.
Use the following instructions if
the cutting attachment shield on
the unit is not installed.
Bottom
Clamp
1. Place the cutting head shield
onto the guard mount
bracket, making sure to align
the holes on the shield with
the ones in the guard mount
bracket. (Fig. 2)
2. Take the 2 shield screws and
screw each one into the
shield until finger tight.
4
Muffler
Spark Plug
Fuel Cap
Barrier Bar
Primer Bulb
To prevent serious personal injury, never operate
Cutting
Head Shield
Starter Rope
Grip
Air Filter
Cover
(2) Screws
Guard
Mount
Bracket
Fig. 2