Descargar Imprimir esta página

Adjusting Saw Chain Tension - Makita XCU11 Manual De Instrucciones

Electrosierra inalámbrica

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjusting saw chain tension

CAUTION:
Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.
CAUTION:
Do not tighten the saw chain too
much. Excessively high tension of saw chain may
cause breakage of saw chain, wear of the guide bar
CAUTION:
A chain which is too loose can
accident.
The saw chain may become loose after many hours
of use. From time to time check the saw chain tension
before use.
1.
Pull the lever up while pressing its edge.
Fig.17
1. Lever
2.
Turn the lever counterclockwise a little to loosen
the sprocket cover lightly.
Fig.18
1. Lever 2. Sprocket cover
3.
the "+" direction to tighten. Tighten the saw chain until the lower
Fig.19
1.
1
4.
Keep holding the guide bar lightly and tighten the
sprocket cover. Make sure that the saw chain does not
loose at the lower side.
5.
Return the lever to the original position.
side of the bar.
OPERATION
Lubrication
CAUTION:
the tank is empty. Replenish the oil in due time
before the tank is empty.
CAUTION:
1
tact with the skin and eyes. Contact with the eyes causes
2
immediately with clear water, then consult a doctor at once.
CAUTION:
carcinogenic substances. The contaminants in waste
oil cause accelerated wear of the oil pump, the bar and
the chain. Waste oil is harmful to the environment.
NOTICE:
time, it may take up to two minutes for the saw chain
anism. Run the saw without load until it does so.
NOTICE:
The oil delivery may otherwise be impaired.
NOTICE:
chain saws or equivalent oil available in the market.
NOTICE:
cles or volatile oil.
NOTICE:
Mineral oil may harm trees.
NOTICE:
that the provided oil tank cap is screwed in place.
12 ENGLISH
2. Guide bar 3. Saw chain
Do not operate the chain saw when
Prevent the oil from coming into con-
Never use waste oil. Waste oil contains
Use the saw chain oil exclusively for Makita
Never use oil including dust and parti-
When pruning trees, use botanical oil.
Before the cutting operation, make sure
-
1
2
3
-
-

Publicidad

loading

Este manual también es adecuado para:

Xcu11z