Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac EA Serie Manual Del Usuario

17. Insert machine hose end with locking-nut into inlet
of tank. Turn locking nut to tighten. Do not over-tighten.
FIGURE 16
19. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 16.
20. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your
local dealer or Shop-Vac ® website.
Questions?
Visit www.shopvac.com 24 hours a day.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
PAGE 6
18. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 16.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
21. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag (not
standard with all models) must be used with the
cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20
FIGURE 21
22. With the tank cover in
an upside down position,
slide the cartridge filter
down over the lid cage,
pushing until the filter seals
against the cover.
FIGURE 17.
23. Place filter retainer
into the top of the cartridge
filter. FIGURE 18.
24. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise
to tighten, locking the filter
into place. FIGURE 19.
25. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise
to loosen and remove.
FIGURE 20.
26. Slide the cartridge filter
off the lid cage.
FIGURE 21.