Alarm Settings; Snooze Function - Emos E5101 Manual De Instrucciones

• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.
If the weather station cannot detect the DCF signal, time and date must be set manually.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must always set the correct time zone for the country where you are using the
station, see Manual Setting of Time and Date. The current time will be shown with the appropriate
time zone difference.
Note: It may take up to 30 minutes since the insertion of batteries into the units before the station
begins showing all the correct measured data and loads DCF signal.
Manual Setting of Time and Date
1. While in time display mode, press the "MODE" button for 3 seconds.
2. Use the " " or " " buttons to set the following parameters and confirm with "MODE" in the
following order: year – month – day – time zone (-12 to +12) – time format 12/24 h – calendar
language (EN – English, GE – German, SP – Spanish, IT – Italian, FR – French, DU – Dutch, DA –
Danish) – unit of pressure (inhg or hpa) – hour – minute.

Alarm Settings

The weather station allows you to set 2 separate alarm times.
Repeatedly press the MODE button and select alarm time no. 1 (A1) or alarm time no. 2 (A2).
To activate the alarm, press " " or " ". The
or " " button deactivates the alarm; the icon will disappear (inactive).
Then, long-press the MODE button to set your alarm of choice; the time setting will start flashing.
Set the alarm time using the " " or " " buttons; to switch selection, press the MODE button again.
Based on the settings, the display will show an icon of the corresponding alarm.
The alarm will then activate at the set time. The alarm rings for 2 minutes unless a button is pressed.
If you wish to deactivate the alarm, repeatedly press the MODE button to select the alarm of choice
and press " " or " "to deactivate it. The alarm icon will disappear from the screen.

Snooze Function

Alarm ringing can be postponed by 5 minutes by pressing the SNOOZE/LIGHT button located on the
top of the weather station.
Press the button when the alarm starts ringing. The alarm icon
To cancel SNOOZE mode, press any other button – the icon will stop flashing and will remain on
the screen.
The alarm will be re-activated the next day.
If you do not press any button while the alarm is ringing, the ringing will stop automatically after
2 minutes.
Indoor and Outdoor Temperature, °C/°F Temperature Unit Setting
Indoor temperature is displayed in field 22.
Outdoor temperature is displayed in field 15.
Repeatedly press the " " button to switch between °C/°F units.
Displaying Maximum and Minimum Temperature/Humidity Readings
Repeatedly pressing the " " button will gradually display the maximum (MAX icon) and minimum
(MIN icon) temperature/humidity readings.
If you hold the " " button for more than 3 seconds, the memory of MAX/MIN readings will be erased.
Setting Outdoor Temperature Alert
• Long-press the " " button until ON/OFF in field no. 15 begins flashing; then, use the " " and
" " buttons to select ON or OFF.
• Press the "MODE" button and then use the " " and " " buttons to set the desired temperature
for the upper temperature limit (
• Press the "MODE" button and then use the " " and " " buttons to set the desired temperature
for the lower temperature limit (
icon will appear (active). Another press of the " "
icon).
icon).
6
will be flashing.