Publicidad
Idiomas disponibles
Idiomas disponibles
•
Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
•
Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
•
Let the product become cool before you do
maintenance near the engine.
•
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
•
Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
Introduction
WARNING:
safety chapter before you assemble the
product.
To remove the product from the carton
1. Remove loose parts included with the product.
2. Remove the end panels.
3. Remove the side panels and put them on a flat
surface.
4. Remove all package materials.
5. Remove the product from the carton and make sure
no loose parts are left in the carton.
Assembly tools
•
1/2" (13 mm) wrench
•
7/16" (11 mm) wrenches (2 pieces)
•
Tire pressure gauge
•
Knife
•
Pliers
•
Socket wrench set (optional)
Loose parts that need assembly
The product is not fully assembled. The parts that follow
are loose when the product is purchased.
Key, 2 pcs
Slope sheet, 1 pcs
Oil drain tube, 1 pcs
10
Assembly
Read and understand the
CAUTION:
instructions that follow before you use the
product.
•
Do not turn over the engine if the spark plug or
ignition cable is removed.
•
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
•
Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged.
•
The product is approved only with the equipment
supplied or recommended by the manufacturer.
Hose connector, 1 pcs
Hex bolt, 2 pcs
Nuts, 2 pcs
To adjust the seat
1. Lift the seat up and remove the seat adjustment
knob (A).
2. Loosen the seat adjustment knob (B).
A
3. Move the seat until it is in a position where you can
push the brake and clutch pedals down.
Read the caution
B
1932 - 004 - 13.10.2022
Publicidad
Solución de problemas
