Electrical System Maintenance; Removing The Battery - SHERCO 250-300 SE/R 2013 Manual Del Propietário

250-300 SE/R
Brakes (continued)
2

electrical system maintenance

reMOving THe BaTTery

2
118
All manuals and user guides at all-guides.com
1
1
3
Install the new pads.
Reinstall the retaining pins
Check the brake fluid level and fill if necessary.
( p.114 et p. 116)
☛
aTTenTiOn
Do not use the bike until the brake lever and the pedal
are operational. «Pump» the brake lever / brake pedal
up and down until the brake pads are in contact with
the discs.
Turn off all electric devices and stop the engine.
aTTenTiOn
- 250-300 SE (standard): Confirm that the key start is in
the OFF position.
- 250-300 SE/R (racing): Confirm that the on / off swit-
ch is in the OFF position.
Risk of damage to the CDI.
- Remove the seat (
☛
- Remove the air filter (
- The battery is located at the bottom of the filter
housing.
- Remove the two screws
battery retaining bracket.
- Disconnect the negative cable from the battery
- Disconnect the battery positive cable
- Remove the battery from the top.
and clips
2 1
p.100)
p.100).
☛
that retain the
1
.
3
.
2