Overview; Preparing And Setting Up - SPORTSTECH VP500 Manual De Usuario

2. Overview

Push-up handles
(use optional)
/ Chair legs
Holding opening with
cover
LED strip
Eyelet for
Full-Body-Band
Carrying handle
(extendable)

3. Preparing and setting up

3.1 SETTING UP AND CONNECTING THE PLATE
1.
Select a suitable setup location for the device:
- with at least 2 m (6.6 ft) clearance around the device,
- floor stable, level, clean and with protective underlay
2.
Align the feet of the device so that it is absolutely level and safe.
For this, if necessary, turn at least one foot in or out a few tenths of an inch.
3.
Connect the electrical power cable to the device and the other end to the wall socket.
3.2 PREPARING THE REMOTE CONTROL BATTERY
On delivery, the battery is protected from discharge by a small piece of foil in the case.
1.
Remove the wristband from the housing of the remote control.
2.
Open the circular cover on the back of the bracelet remote control and remove the battery and the
insulating sheet.
3.
Put the battery back with proper polarity. Re-attach the cover and close it.
4. Reassemble remote control and wristband.
3.3 TRANSPORT
Lift the vibration plate by the carrying handle and move it to the desired place.
22
Stand Electrical
connection
Chair seat
(use optional)
Eyelet for power strap
Remote control
(Storage position)
min. 2 m
(6.6 ft)
Stand area
Control panel
Transport roller
(swivellable)