Securing The Child - Diono Monterey 4DXT Manual De Instrucciones

SECURING THE CHILD

WARNING! Use ONLY the lap and shoulder belt system
when restraining the child in this booster seat.
lap belt only.
1. Properly position child into
installed seat. Child should be sitting
upright and seated all the way back
in the booster seat.
2. Adjust head support to proper
height: The RED shoulder belt guide should be slightly
above the child's shoulders (at least 1 cm). Squeeze the
head support adjustment lever on the back of the
booster seat while adjusting it's height up or down to fit
the child.
2
3. Feed the diagonal portion of the
vehicle seat belt through the
shoulder belt guide.
22
monterey 4DXT
DO NOT use
1
RED
3
4. Fasten vehicle seat belt across child.
The lap portion of the seat belt should
rest within both lower belt guides.
Make sure the vehicle seat belt is not
twisted and lays flat across child's lap,
torso and shoulder.
5. Tighten the seat belt by pulling the
diagonal shoulder belt portion in
the direction of the arrows.
6. Confirm seat belt buckle is in
correct position – it should align
with the RED belt path guides on
headrest and side of seat.
IMPORTANT: The vehicle shoulder belt
MUST route completely through the
RED shoulder belt guide and not fall off
the child's shoulder.
IMPORTANT: DO NOT position the vehicle lap belt over the
armrest. It MUST pass through the lower belt guide.
IMPORTANT: The vehicle shoulder belt should lay over the
shoulder and should NOT be touching the child's neck.
diono.com
SECURING THE CHILD
4
5
6
click
23