Parts Detail; Specifications - Permobil Smart Check Manual De Instrucciones

Parts Detail

Package Contents: Smart Check, storage case, operation manual, limited warranty
supplement, product registration card
To order replacement parts, contact the equipment provider or Customer Support.
*Refer to instructions for faceplate details.
Refer also to the instructions provided with the cushion.

Specifications

Storage Conditions
+70°C (158°F)
-25°C (-13°F)
Materials:
Smart Check: polycarbonate with
polyester faceplate; Storage Case:
polystyrene; Tubing: polyurethane;
Quick Disconnect: acetal
Expected Service Life: 5 years
Batteries: one (1) year typical
operating time
Overview
This page explains how to use Smart Check to find, save, and check your cushion inflation setting.
Read this overview and all instructions before using Smart Check.
Warnings:
- Perform Setup (either Smart Setup or Optional Setup) when using Smart Check for the first time.
- Perform Smart Setup or Optional Setup again if the following changes occur: 1) a different
individual is using Smart Check; 2) a different chair or a different cushion is being used; or 3) the
individual experiences physiological changes (for example, weight loss or weight gain).
Smart Setup:
To use Smart Check to perform a Smart Setup: First, follow the "Smart Setup Instructions": Smart Check will find and save your cushion inflation
setting for you. Then, follow the "Check Instructions": when you press the Check Button, Smart Check will tell you if you need to adjust your
cushion.
Optional Setup:
Optional Setup is an alternative to Smart Setup. Optional Setup may be preferred in the following situations:
- A qualified seating specialist has determined an alternate immersion and envelopment level for the individual.
- The individual must accommodate needs (such as severe asymmetrical posture) that are beyond the immersion and envelopment setting
found by Smart Check during Smart Setup.
- The cushion is being used on an upholstered surface (such as a Captain's Seat).
To use Smart Check to perform the Optional Setup: First, find your preferred cushion inflation setting without using Smart Check; follow the
instructions provided with the cushion. Then, follow the "Optional Setup Instructions" in this manual, using Smart Check to save your inflation
setting. Finally, follow the "Check Instructions" in this manual. When you press the Check Button, Smart Check will tell you if you need to adjust
your cushion.
Smart Check Operation Manual
Operating Conditions
93%
0-5%
Altitude Limitation (above sea level): Lower -410 m ( -1,350 ft.) ; Upper 3185 m (10,450 ft)
This product complies with RoHS2.
Smart Check is a type BF Applied Part. Smart Check has been tested
and complies with IEC 60601-1, IEC 60601-1-2, and IEC 60601-1-11;
certified to CAN/CSA Standard C22.2 No. 60601-1. Electromagnetic
interference is not caused by Smart Check and does not interfere with
Smart Check.
Smart Check is an IP54-rated device (protected from dust and
splashing water).
Smart Check Faceplate*
48°C
(118°F)
0°C
(32°F)
0-5%
3
Quick Disconnect
Storage Case
Tubing
93%
700 hPa
Products and Accessories
Compatible with Smart Check:
Note: Not available in all markets.
Contact Customer Support.
ROHO Covers: Standard, Heavy Duty
and Hybrid Elite
ROHO Cushions: Sensor Ready and
Hybrid Elite SR
ROHO Hand Pump
Proper Cushion Inflation Setting:
A) sink down into the cushion and
B) "float" above the cushion base.
1060 hPa