Optional Setup Instructions - Permobil Smart Check Manual De Instrucciones

Optional Setup Instructions

Optional Setup is an alternative to Smart Setup that records your preferred cushion inflation setting.
See "Overview" for more information.
Warnings:
- Optional Setup should not be used if the individual weighs less than 90 lbs. (40 kg).
- It is recommended that a qualified seating specialist be consulted when saving a preferred
cushion inflation setting with Optional Setup.
- Perform the following steps in the usual environmental conditions.
Part One: Adjust Your Cushion Without Smart Check
1. Perform a Hard Reset. See "Hard Reset Instructions."
Note: For first-time use, remove the battery pull tab.
2. Inflate the cushion and place it in the chair. Sit on the cushion in your usual position.
3. Adjust the cushion; see the instructions provided with the cushion.
4. Perform a hand check to confirm immersion and envelopment. (See the "Hand Check Guide" in this manual.)
Part Two: Save Your Setting With Smart Check
5. Make sure Smart Check is attached to the cushion. You will hear a "click"
when the connection is secure.
6. Make sure the inflation valve is closed.
7. Press the Check Button () to activate Smart Check. You will see either a red
up arrow () or a red down arrow () light. DO NOT add or remove air.
8. Press and hold the Setup Button for four (4) seconds until you see a green
light. Your cushion is now set up. Next: See "Check Instructions."
The green light means that your preferred cushion inflation setting has
been saved. The green light DOES NOT indicate a Proper Cushion Inflation
Setting (see "Overview" for more information).
Warnings: Store Smart Check in a safe, accessible location. See "Disconnection, Storage and Transport." • Confirm that Smart Check is not
pressing against your body.
Smart Check Operation Manual
6
Symbols and Lights for Optional Setup
Setup
Button
Green Light
"Setup is complete."
Quick Disconnect
4s
Check
Button