Publicidad
Tighten up the rotating table to make miter cuts
• To make 45° and up to -45° miter cuts use the rotating
table (15).
• Loosen the control knob (17) to release the rotating
table.
• Turn the table into the desired angle. Use the miter scale
(18) as an aid. This scale is built with 0°, ±15°, ±22.5 °
±30° and ±45° stops to quickly set the most common
miter angles.
• Release the blocking lock to fix the table.
WARNING
• Double-check the knob is tightened to
fix the table before starting to cut. Otherwise the table
could move and cause a severe injury.
Tighten up the cutter head to make bevel cuts
• To make up to ±45° bevel cuts adjust the cutter head
column into the desired angle.
• Loosen the bevel cut knob (25).
• Pull out the blocking lock for 0° bevel cuts (28) to release
the cutting head column. Move the column using the bevel
cut scale (26) as a guide.
• Once the column is in the desired angle tighten the knob
to block its position.
WARNING
• Double-check to tighten the knob to
fix the column before starting to cut. Otherwise the cutter
head could move and cause severe injury.
• To return the cutter head to 0° position loosen the bevel
cut knob and return the column to 0° position until the
blocking lock for 0° bevel cuts gets automatically inserted
and securing the column in that position. Tighten the bevel
cut knob.
35°
bevel cut
10
ENGLISH
25
26
0°
bevel cut
28
Tightening Up
15
16
17
45° miter cut
0° miter cut
-45° miter cut
Publicidad
