I N S T A L L I N G T H E H A N D L E B A R
The stem comes pre-installed and aligned on the bicycle. The handlebar assembly needs to be
installed on the stem.
3.11
A
B
Fig. 3.11
Loosen the faceplate bolts (A) to remove the faceplate (B) from the stem (C).
Place the handlebar against the stem.
Thread each bolt through the faceplate and into the stem body until they are equally finger-
tightened and the upper and lower gaps between the stem body and faceplate are equal
(D).
3.12
C
D
Fig. 3.12
Make sure the handlebar is centered with the stem by vertically and horizontally centering
the handlebar logo in the stem faceplate.
Visit
specialized.com/setupmyjett
handlebar should be set to for the rider.
to determine the number position the
10