JETT 16 Guía De Montaje página 14

3.15
Fig. 3.15
The stem comes pre-installed and aligned. Should you need to adjust the stem, use the
„
supplied wrench to loosen the bolts on the rear of the stem and adjust the stem and
handlebar's angle to be in line with the front wheel.
Once aligned, retorque the rear stem bolts using the supplied torque wrench and 4 mm hex
„
bit to 5 Nm / 45 in-lbf.
A D J U S T I N G T H E S E A T P O S T H E I G H T
5
Nm
3.16
45
4 in-lbf
mm
Fig. 3.16
Using the 5 mm hex bit, loosen the seat collar bolt.
„
Set the saddle height at a position that you feel approximates the correct height for the
„
rider, then tighten the seat collar bolt.
12