Publicidad
Idiomas disponibles
Idiomas disponibles
4. Cut the nylon straps securing the battery/charger boxes, seat, and mower front wheels (Fig. 3b).
5. Remove the seat assembly from the mower first, and then remove the battery and charger boxes from the bottom of
the frame (Fig. 3b).
6. Remove and set aside all accessible packaging and wrap material. Do not discard the packing material until you
have carefully inspected the product.
NOTICE: Do not remove the steering wheel protector that protects the steering wheel until the steering wheel is
properly installed. Vibration during the removal of the mower may cause damage to the steering wheel.
7. Remove both wheel chocks from in front of the wheels. You may need to use the supplied wrench to pry off the
chocks (Fig. 3b).
8. If a ramp is available, position a full-width ramp against the bottom frame, close to the front wheels. Do not exceed
the maximum recommend operating angle of 15°. Alternatively, two pieces of 2x4 lumber help reduce the "drop"
from the bottom frame to the ground.
9. Press the parking-brake pedal to release it from the braking position. A significant effort is required to release the
parking-brake pedal by hand. Push hard!
CAUTION: Heavy object. Team push required. At least two persons are required to push this mower off of the steel
frame.
10. Grasp the rear corners and the areas around storage compartment / cup holder of the mower simultaneously on
both sides and slowly push the mower off of the steel frame in the forward direction (Fig. 3b).
NOTICE: ONLY PUSH THE MOWER FORWARD. Pulling the mower backward from the steel frame may cause damage to
the mower's cutting deck. Always remove the mower from the frame in the forward direction!
NOTICE: The mower must be transported on the bottom frame at all times! Fork lift should never come in direct contact
with the mower! Doing so may cause damage.
11. Cut the nylon strap securing the side discharge chute once the mower is on the ground.
WARNING: Do not use this product if any parts are already assembled to your product when you unpack it. Parts on
the packing list are not assembled to the product by the manufacturer and require customer installation. Use of a product
that may have been improperly assembled could result in serious personal injury.
◾
Inspect the product carefully to make sure that no breakage or damage occurred during shipping.
◾
If any parts are damaged or missing, please contact EGO after sale service.
24
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200S/ZT4200S-FC
Publicidad
